Join and use your tutor

AIPLA student guide — S1

For students

You do not need an account or a password. Your teacher gives you a short group code — that is all you need to start. This takes about a minute.

Step 1 — Open the link and type your code

Open the student link your teacher gave you. You will see a join page. Type your group code — it looks like bright-fox-42 — and select Join (Tilslut).

Type the group code your teacher gave you, then Join.

Your code keeps your group’s work together. There is nothing to remember and nothing to install.

Step 2 — Choose your activity

After you join, you see the activities your teacher has set up. Select the one you are working on.

Pick the activity your teacher set for you.

Step 3 — Work with the tutor

The activity opens with two sides: the tutor you chat with, and your workspace — a simulation, a checklist, a table, or notes, depending on the activity. Ask the tutor questions in your own words; it guides you toward understanding rather than just giving answers.

The tutor on one side, your workspace on the other.

Tip

Anything you do in the workspace — values you enter, a simulation you run, steps you tick off — is shared with the tutor, so it can help you with your actual work.

If your code stops working

Group codes can expire, or your teacher may give you a new one. If joining fails, ask your teacher for the current code. Closing the tab signs you out of the group — just open the link and type your code again.